Recovery Mode of FLYC-300

Put FLYC-300 into Recovery Mode

• Please follow [LINK] to config the DIP switch properly

• Unplug the DC input

• Hold down the recovery button. The recovery button is underneath the USB ports, as the above red cycle highlighted

• While the recovery button is hold down. Power on the PCBA

• After 5 seconds, release the recovery button

Confirm if FLYC-300 put into Recovery Mode

• Prepare a USB type C to USB type A cable

• Connect the type C port on FLYC-300 with the USB 2.0 port on the host computer with the above cable.

• On the host computer, enter lsusb in the terminal. Then, you will see " NVIDIA Corp. APX"