Assemble / Disassemble

This page is still under construction.

Let's begin with the most critical part.

While trying to assemble NRU-220S, please bear in mind that the final step for assembling would be integrating Part A and Part B. The same principles applied to disassembling.

Before sliding Part B into Part A, please make sure the implant nails on Part B and the holes on Part A are matched. The relative position between Part A and Part B will look like the below.

While sliding Part B into Part A, please gently check from the front panel to make sure the IO on PCBA can slightly pass through the front panel.

Then, gently slide Part B into Part A.